Payment & Shipping Terms:
|Size:||1.6-2.5mm, 3.0-5.0mm||Bulk Density:||≥0.75g/ml,0.68g/ml|
|Water Adsorption:||≥21.0%||Ethylene Adsorption:||≤3.0mg/g|
|Attrition Rate:||≤0.1%||Package Moisture:||≤1.5%|
molecular sieve type 3a,
3 angstrom molecular sieves,
insulated glass molecular sieve type 3a
3a Molecular Sieve Desiccant For Insulated Glass With High Water Adsorption Capacity
The molecular sieve 3A beads are widely helpful in drying the inner space of insulating glass, to help in protecting the insulated glass units due to its high water adsorption capacity and better-quality physical properties. These are basically used for the bright, clean and transparent appearance of the glass even at the very low temperature. 3A molecules have the ability to absorb the water as the hollow glass desiccant and ensure prolong the lifespan of hollow glass windows considerably. Molecular sieve 3A in the form of beads in varied series are available to adsorb humidity without freezing and damaging the glass surface, as well as to prevent the glass from yielding.
Such type of desiccant is highly appreciable in constructing the energy saving house or buildings. It can resolve window distortion issue originated by inflation and shrinking occurs either in different seasons or in different temperature throughout the day. Such potassium form of type A crystal structure is a suitable state of dehydration of insulating glass units either in the air-filled or gas-filled state. 3A desiccant is highly effective at low moisture levels. The beads and pellets are filled and separated by the spacer bar by means of dedicated tools and then sealed.
The reason of using 3A desiccant for insulated glass industry is its high water adsorption capability at the extremely low level of moisture. Such properties ensure to obtain highly durable glass with the clear complexion. Not only this, they have the power to avoid any kind of additional air molecules that can convert into glass deflection and its panel. Using 3A desiccant for glass application is helpful in protecting the glass from long-term defects.
|Insulated Glass Drying Molecular Sieve Type A Typical Physical Properties|
|Bulk Density||g/ml ≥||0.72-0.82||0.70-0.80||0.68-0.78|
|Equilibrium Water Capacity @ 25℃||wt% ≥||19.0-21.5||19.0-21.5||19.0-21.5|
|Equilibrium Nitrogen Capacity||mg/g ≤||2.0||2.0||2.0|
|Heat of Adsorption||BTU/lb of H2O||1800||1800||1800|
|Crush Strength||Point Contact||N ≥||-||10-20||30-50|
|Dust(Turbidity Meter)||ppm ≤||30||30||30|
|De4lta T*(10g/10ml H2O)||℃ ≥||38||38||38|
|Dew Point||℃ ≤||-73||-73||-73|
|Loss of Ignition(950℃)||wt% ≤||2||2||2|
|Size Qualification||% ≥||96||96||96|
|Package Moisture||wt% ≤||1.5||1.5||1.5|
|The interval value of the indexes above are on the basis of the different grade of Insulated Glass Desiccant|
1. High moisture adsorption ability
2. Consistent moisture adsorption rate
3. Low dust level & dew point
4. Small adsorption of gas
5. High crushing strength
The molecular sieve shall be stored at room temperature, in which the relative humidity does not exceed 90%, and be not exposed to air, and prevented against water, acids and alkalizes.
Contact Person: cooperfan